Maytag Washer Repair

People who own washers would want to learn how to repair or troubleshoot these washers, and this article would be focusing particularly on Maytag washer repair. This may serve as a guide in helping one go through the rights steps when attempting to repair their May tag washers.

Listed below are the most common areas where problems are most likely to strike in Maytag washer repair problem.

Maytag Washer Repair #1 – The Lid Switch

This part is the probably the most common area of problems in Maytag washers. There is a problem whenever the lid switch does not make any noise when the washer is turned on. Make sure to check out the lid switch actuator by opening the washer’s lid and looking just right behind it. Press the small, white button using a bread knife. If it retracts right back in, then it means that the actuator is fine. If the button is not visible, then it means that the actuator already needs replacing. However, if the actuator is fine, then the problem most probably lies within the lid switch.

Maytag Washer Repair #2 – Belts

Maytag washer repair also identifies belts as a source of problem among Maytag washers. There are two kinds of belts used by Maytag washers ─ the drive belt and the pump belt. The larger belt is the drive belt which leads to the pulley of transmission. The smaller belt, the pump belt, leads to the pump as the name suggests. If either of the two belts is defective, then it may be the reason why the washer does not spin properly.

Be sure to check these belts every once in a while. Do this by disconnecting the washer from power and by tilting over the washer for easier access to the belts. Check if the belts are adjusted properly, not too tight and not too loose. Inspect them and replace them when they appear damaged or worn out.

Maytag Washer Repair #3 – Pump

Another area of focus of this repair guide is the pump. Although they do not go bad that often, it is common that things may get hung in them. There will be difficulty in pumping out water if this happens. To check the pump on your Maytag washer, again disconnect it from power and take off the front panel by taking off the two screws found at the bottom part of the front panel. The pump is usually n the right hand side. Remove water from your washer first before doing this.

Maytag Washer Repair #4 – Motor

Like pumps, this guide identifies motors as not a likely source of problem but may sometimes go bad. Maytag washers with motors not being able to freely move back and forth, then the motors will not be able to start resulting to the washer not running. In doing repairs on this part, check both the rollers (if they are working well) and the motor itself.

Repairing your Maytag washer would be easier knowing which parts are the most common areas of problems. One should know that in referring to a Maytag washer repair guide, he should read well on it first before attempting to repair a Maytag washer by himself. An effective Maytag washer repair guide is one which is released by the manufacturers of the product itself.